Table of Contents
Advertisement
To remove this delay, scan the Intercharacter Delay barcode, then set the number
of delays to 0. Scan the Save barcode from the
page 291.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays from the
Programming Chart,
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a
printable character to trigger the delay (see
283.
To remove this delay, scan the Delay Length barcode, and set the number of
delays to 0. Scan the Save barcode from the
page 291.
Interfunction Delay
An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each control character in the message string.
Scan the Interfunction Delay barcode below, then scan the number of 5ms delays,
and the Save barcode from the
Granit XP User Guide
beginning on page 291, then Save.
)
Delay Length
Lower ASCII Reference
Programming Chart,
Programming Chart,
Prefix
Scanned Data
STX
1
HT
2 3 4 5
Interfunction Delays
Interfunction Delay
Programming Chart,
Character to Trigger Delay
beginning on
beginning on page 291.
Suffix
CR
LF
beginning on
Table, page
119
Advertisement
Table of Contents
