Hands Free Time-Out; Reread Delay - Honeywell Granit XP 199 i Series User Manual

Hands Free Time-Out

The Scan Stand and Presentation Modes are referred to as "hands free" modes. If
the scanner's trigger is pulled when using a hands free mode, the scanner changes
to manual trigger mode. You can set the time the scanner should remain in manual
trigger mode by setting the Hands Free Time-Out. Once the time-out value is
reached, (if there have been no further trigger pulls) the scanner reverts to the
original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from 0-
300,000 milliseconds) from the
Save. Default = 5,000 ms.

Reread Delay

This sets the time period before the scanner can read the same barcode a second
time. Setting a reread delay protects against accidental rereads of the same bar-
code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive barcode scanning is required. Reread Delay
only works when in a
94
Presentation Mode
Short (500 ms)
Long (1000 ms)
Programming Chart,
Hands Free Time-Out
(see page 88). Default = Medium.
beginning on page 291, then
* Medium (750 ms)
Extra Long (2000 ms)
Granit XP User Guide