Other Programming Selections - Honeywell Granit XP 199 i Series User Manual

Note: 9999 indicates all lengths.
Step 6.
Step 7.

Other Programming Selections

•
•
•
•
Granit XP User Guide
Chart, beginning on page 291. For example, 50 characters is entered as
0050.
Editor Commands
Refer to Data Format Editor Commands
that represent the command you want to enter.
Scan Save to save your data format, or Discard to exit without saving your
changes.
Enter Data Format
Discard
Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary
format, scan 0 from the
clearing an alternate format, scan 1, 2, or 3, depending on the format you are
clearing. Scan the Terminal Type and Code I.D. (see
279), and the barcode data length for the specific data format that you want to
delete. All other formats remain unaffected.
Clear all Data Formats
This clears all data formats.
Save
Exit and save your data format changes.
Discard
Exit without saving any data format changes.
Clear One Data Format
Programming Chart,
(page 124). Scan the symbols
beginning on page 291. If you are
Symbology Charts
Clear All Data Formats
Save
on page
123