Reset The Factory Defaults - Honeywell Granit XP 199 i Series User Manual

Reset the Factory Defaults

Caution: This selection erases all your settings and resets the scanner to the
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the scanner to factory default settings,
first scan the Remove Custom Defaults barcode, then scan Activate Defaults.
This resets the scanner to the factory default settings.
Remove Custom Defaults
Note: If using a cordless system, scanning the Activate Defaults barcode also causes both
the scanner and the base or Access Point to perform a reset and become unlinked.
The scanner must be placed in its base to re-establish the link before any setup codes
are entered. If using an Access Point, the linking barcode must be scanned. See
Cordless System Operation
The
each of the commands (indicated by an asterisk (*) on the programming pages).
228
original factory defaults. It also disables all plugins.
Menu Commands, beginning on page 234, list the factory default settings for
beginning on page 39 for additional information.
Activate Defaults
Granit XP User Guide