Straight 2 Of 5 Iata (Two-Bar Start/Stop) - Honeywell Granit XP 199 i Series User Manual

Straight 2 of 5 IATA (two-bar start/stop)

Straight 2 of 5 IATA On/Off
Straight 2 of 5 IATA Redundancy
If you are encountering errors when reading Straight 2 of 5 IATA barcodes, you may
want to adjust the redundancy count. Redundancy adjusts the number of times a
barcode is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the
barcode. To adjust the redundancy, scan the Straight 2 of 5 IATA Redundancy bar-
code below, then scan a redundancy count between 0 and 10 on the
Chart,
Straight 2 of 5 IATA Message Length
Scan the barcodes below to change the message length. Refer to
Description
lengths = 1-48. Minimum Default = 4, Maximum Default = 48.
Minimum Message Length
154
<Default All Straight 2 of 5 IATA Settings>
On
beginning on page 291. Then scan the Save barcode. Default = 0.
(page 142) for additional information. Minimum and Maximum
Straight 2 of 5 IATA
Redundancy
* Off
Programming
Message Length
Maximum Message Length
Granit XP User Guide