Digimarc Barcode - Honeywell Granit XP 199 i Series User Manual

Digimarc Barcode™

Digimarc Decoder Attempts
Set the number of attempts by scanning the barcode below, then setting the num-
ber of attempts (0-10) by scanning digits from the
on page 291 of this manual, the Save. Minimum to Maximum attempts = 0-10.
Default = 3.
Digimarc Barcode
This setting programs the scanner to decode Digimarc Barcode using Digimarc
and ID decoders. When Digimarc Barcode is set to On, the Digimarc decoder is
used on most frames and the ID decoder will read every fifth frame.
When Digimarc Barcode is set to Uses ID Decoder then Both Decoders, the ID
decoder will read the number of attempts set by the Digimarc Decoder Attempts
and then will use both ID and Digimarc decoders. When Digimarc Barcode is set to
Uses Digimarc Decoder then Both Decoders, the Digimarc decoder will read the
number of attempts set by the Digimarc Decoder Attempts and then will use both
ID and Digimarc decoders.
When Digimarc Barcdoe is set to Uses ID Decoder then Alternates Decoders, the
ID decoder will read the number of attempts set by the Digimarc Decoder Attempts
and then will alternate between ID and Digimarc decoders. When Digimarc Bar-
code is set to Uses Digimarc Decoder then Alternates Decoders, the Digimarc
decoder will read the number of attempts set by the Digimarc Decoder Attempts
and then will alternate between ID and Digimarc decoders.
Default = DIGENA0: Off
Granit XP User Guide
*Off
Uses ID Decoder then Both
Decoders
Digimarc Decoder Attempts
Programming Chart
On
beginning
191