User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart,
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced barcode
is scanned, the aimer is interlaced with the illumination LEDs. Default = Interlaced
Laser Aimer - Scan Duration
Use the following bar codes to specify how long you want the laser aimer to remain
on after the trigger is released. Scan the 10 Second Scan Duration bar code to set
the duration to 10 seconds (default) . Scan the Laser Aimer - Scan Duration bar
code to set a different duration, then set the duration by scanning digits
(0 - 65,535 ms) from the Programming Chart, beginning on page 353. Scan Save
to finish.
Granit XP User Guide
beginning on page 291, then Save.
Off
*10 Second Scan Duration
Delay Duration
* Interlaced
Laser-Aimer Scan Duration
99