Number of Beeps - Base Error
The number of beeps and LED flashes emitted by the base for an error condition
can be programmed from 1 - 9. For example, if you program this option to have five
error beeps, there will be five error beeps and five LED flashes in response to an
error. To change the number of error beeps, scan the barcode below and then scan
a digit (1-9) from the
Default = 1.
Scanner Report
Scan the barcode below to generate a report for the connected scanners. The
report indicates the port, work group, scanner name, and address. To assign a
name to your scanner, refer to
Scanner Address
Scan the barcode below to determine the address of the scanner you are using.
Base or Access Point Address
Scan the barcode below to determine the address of the base or Access Point you
are using.
Scanner Modes
Your scanner is capable of working in single scanner mode, multiple scanner
mode, or with Bluetooth devices other than a charge base or Access Point.
52
Programming Chart,
Number of Base Error Beeps/LED Flashes
Menu Command
Scanner Report
Scanner Address
Base Address
beginning on page 291, then Save.
Syntax, page 229.
Granit XP User Guide