Remote Control; Introduction To Sis; Error Messages; Timeout - Extron electronics DTP2 T 211 User Manual

Remote Control

Use Simple Instruction Set (SIS) commands to configure the DTP2 211 transmitter and
receiver. This section provides information about using those commands. The following
topics are discussed:
•
•
•
•

Introduction to SIS

The DTP2 211 transmitter and receiver accept SIS commands from a host device such as a
computer running the Extron DataViewer utility or other control system. The host device can
be connected to the Config port on the front panel (see
USB Port
SIS commands consist of strings (one or more characters per command field). Upper
and lower case characters can be used interchangeably. Commands do not require any
special characters to begin or end the command string. Each response from the DTP2 211
transmitter and receiver ends with a carriage return and a line feed (CR/LF =
signals the end of the response character string.
When the transmitter or receiver is first switched on, it sends the message:
(c) Copyright 2019, Extron Electronics DTP2 T/R 211, Vx.xx 60‑xxxx‑xx

Error Messages

E10
E13

Timeout

Pauses of 10 seconds or longer between command ASCII characters result in a timeout.
The command operation is aborted with no other indication.
Introduction to SIS
Symbols Used in this Guide
Command and Response Table for SIS Commands
Downloading and Updating Firmware
on page 17).
is the firmware version number.
•
Vx.xx
• is the part number of the device.
60‑xxxx‑xx
— Invalid command
— Invalid parameter
Connecting to the Front Panel
]
), which
DTP2 T/R 211 • Remote Control
]
20