Extron electronics FOX II T DP 4K User Manual page 20

Audio connections
NOTE: The level of the analog audio inputs can be set via an
page 21) or using the software
Input control, 9 , in "Product Configuration Software" on page 32).
The following table shows the audio format that is sent over the fiber connection, along with
the DisplayPort video, when the audio input format is set to
the Input audio selection SIS commands
Embedded
DisplayPort Audio
Present
Present
Not present
Not present
3.5 mm TRS input and output connections
See figure 5 to identify the tip, ring, and sleeve when you are making connections for the
transmitter or receiver from existing audio cables. A mono audio connector consists of the
tip and sleeve. A stereo audio connector consists of the tip, ring, and sleeve.
Tip (+)
Ring (-)
Sleeve ( )
3.5 mm Stereo Plug Connector
(balanced)
Figure 5. Stereo Plug Audio Connector
Captive screw input connections
See figure 6 to properly wire a captive screw input connector, either audio input on the
transmitter or return audio input on the receiver.
Tip
Sleeve
Tip
Do not tin the wires!
Sleeve
Unbalanced Stereo Input
Figure 6. Captive Screw Connector Wiring for Stereo Audio Inputs
NOTE: The length of exposed wires is important (see the RS-232 and IR connector
NOTES on the previous page for more information).
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
Analog Input Gain
on page 21 to switch the active audio source).
Analog Audio Transmitted Audio
Not present Embedded audio
Present Embedded audio
Present Analog audio
Not present No audio
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
SIS command (see
Analog
slide control (see the
(the default setting, see
Auto
12