Table of Contents
Advertisement
EDID Select rotary switch
D
switch to one of the positions below to select the source of the DDC or a
specific resolution.
Position 0 — A user-recorded EDID that has been previously:
•
Captured from the display connected to the receiver output.
Captured from the display connected to transmitter DisplayPort Loop-through
•
connector (see
•
Manually imported via an
Software action in the
Position 1 — The EDID is selected via the rear panel Remote RS-232 port or the front
panel Configuration port, using an SIS command or the Product Configuration Software.
This is the factory default position.
Position 2 — The EDID is received from the display connected to the receiver.
NOTE
fiber cables.
Position 3 — The EDID is received from the display connected to the DisplayPort
Loop-through connector (see
Position 4 – E — Specify a resolution. The table below identifies the switch positions
and the associated resolutions. All resolutions are at 60 Hz with the exception of
3840x2160 (E), which is 30 Hz.
Pos. Source or resolution
0
1
2
3
4
5
* 30 Hz
Rear Panel Features
NOTE: The
Reset button — Press and release or press and hold this button to
initiate two levels of transmitter reset (see
(see figure 9 on the previous page) — Set this
item B
, from figure 2, on page 7).
SIS command
EDID minder window
EDID from the display connected to the receiver requires connection of both
:
item B
Pos.
User recorded EDID
Selected via RS-232
Display on Rx output
Display on Tx loop-through
1280x720 (720p)
1280x800
button is in the same location on the transmitter and the receiver.
Reset
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
(see page 20) or Product Configuration
(see page 30) to the transmitter.
).
Resolution
6
1366x768
7
1440x900
8
1680x1050
9
1920x1080 (1080p)
A
1920x1200
B
2048x1536
Performing resets
on the next page).
EDID
SELECT
Pos.
Resolution
C
2048x2160
D
2560x1600
E*
3840x2160
F
N/A
FOX
T DP 4K
RESET
Reset
Button
15
Advertisement
Table of Contents
