Extron electronics FOX II T DP 4K User Manual page 17

Receiver connections
100-240V ~ -.-A MAX
DISPLAYPORT
50-60 Hz
Q Q K K
Figure 3. FOX II R DP 4K Transmitter Rear Panel Connectors
J
Optical ports and LEDs (see below)
K DisplayPort output port
L Analog Audio output ports
M Audio Return In port
Optical ports and LEDs (see figure 3) —
J
The FOX II T DP 4K outputs continuous invisible light (Class 1 rated),
WARNING:
which may be harmful to the eyes; use with caution. Plug the attached dust cap
into the optical transceiver when the fiber optic cable is unplugged.
AVERTISSEMENT : Le FOX II T DP 4K émet une lumière invisible en continu
(conforme à la classe 1) qui peut être dangereux pour les yeux, à utiliser avec
précaution Branchez la protection contre la poussière dans l'ensemble émetteur/
récepteur lorsque le câble fibre optique est débranché.
NOTES:
• You can connect the transmitter and receiver in either of two ways, as shown in
the figure below right:
• One way (transmitter-Tx-to-receiver-Rx) only — Connect fiber cable 3
(from transmitter connector 1 ) only.
• Two way (transmitter to receiver and return) — See the figure below
right. Connect fiber cable 3 (from transmitter connector 1 to the receiver)
and fiber cable 4 back to the transmitter (connector 2 ).
• See the transmitter fiber connector
these connectors.
Rx (required) — For all one-way video, audio, and serial communications from the
3
transmitter to the receiver, connect a fiber optic cable to the Rx LC connector.
Connect the opposite end of this cable to the Tx connector
on the FOX II T DP 4K transmitter (see
to any other compatible Extron fiber optic device.
Tx (optional) — Connect a fiber optic cable to the Tx LC
4
connector for one-way return audio and serial communications
from the receiver to the Rx connector on the transmitter.
NOTE: The Tx connector emits light when the unit is
powered and the Rx port receives light.
Connect the opposite end of this cable to the Rx connector
on the transmitter (see
Tx Link and Rx Link LEDs — When lit, the link is active (light
is received).
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
OUTPUTS AUDIO
RETURN IN
AUDIO
REMOTE
L R L R
L L M M
N
Over Fiber port
(see page 10) O Remote RS-232 port
(see page 10) P Alarm port
(see page 10) Q Power connector
NOTES
item 1
item 2 on page 8).
N N
RS-232 IR
FOX R DP 4K
Tx Rx G Tx Rx
Tx Rx
RS-232
ALARM
RESET
Tx Rx G 1 2
OPTICAL
O O P P J J
(see page 10)
(see page 10)
(see page 10)
(see page 10)
on page 8, which also apply to
Tx
on page 8) or
4 4
OPTICAL
Receiver
Transmitter
Tx
(
1 1
on
OPTICAL
page 8)
Rx
3 3
Rx
(
2 2
on
page 8)
9