Table of Contents
Advertisement
Updating the Firmware
The Product Configuration Software can open the Firmware Loader utility, which provides a
way to replace the transmitter or receiver firmware without taking the unit out of service.
NOTE: Upgrading the firmware does not overwrite the current configuration.
Update the unit firmware as follows:
1.
Perform steps 1 through 7 of
firmware upgrade from the Extron website.
2.
Click
Run
(see
figure
Extron website and starts the Extron Installation Program to extract the firmware file.
3.
Click
Finish
identified in the InstallShield Wizard.
ATTENTION:
•
•
NOTES:
•
•
4.
Click
Finish
5.
Connect the computer to the front panel Configuration port (see
on page 11) of the unit to be updated.
Installing the
in the
File Download and Security Warning
22, 1 on the next page). The PC downloads the firmware update from the
(
). The program extracts the firmware files and places them in a folder
2
The firmware file must have an .s19 extension. Other file types can cause the
unit to stop functioning.
Le firmware doit avoir une extension .S19. D'autres types de fichiers peuvent
nuire au fonctionnement de l'émetteur.
Note the folder to which the firmware file is saved. When downloaded
from the Extron website, the firmware is placed in a subfolder of:
•
64-bit OS:
\
C:
Program Files (x86)\Extron\Firmware
•
32-bit OS:
\
C:
Program Files\Extron\Firmware
The original factory-installed firmware is permanently available on the unit. If
the attempted firmware upload fails, the unit reverts to the factory-installed
firmware.
(
) to exit the program.
3
FOX II T/R DP 4K Transmitter and Receiver • Remote Control
Software, on page 25, to download the
dialog boxes, if applicable
.
.
Configuration Port
36
Advertisement
Table of Contents
