Extron electronics FOX II T DP 4K User Manual page 30

Command and Response Table for Transmitter SIS Commands (continued)
Command
Transmitter name
Assign a name to the device
Reset device name to default
View the device name
Status requests
View Rx link (Rx-to-Tx) status
View input video status
View audio input status
View HDCP status
View temperature
Information requests
Information request
Show firmware version
Example:
Request HDCP output status
Request part number
Request SFP status
Resets
Reset audio
System reset
KEY: X1@ = Transmitter name
X1# = Link status
X1$ = Audio output
X1% = Input HDCP signal
X1^ = Temperature
X1& = Resolution
X1* = EDID switch position
X1( = Firmware version
X2)
= Optical module manufacturer
X2!
= Tx or Rx power
X2@
= Operating temp of module
X2#
= HDCP Output Status
SIS Command Response
(host to unit) (unit to host)
EX1@ }
CN Ipn•
E }
•CN Ipn•FOX-II-T-DP-4K
E } X1@]
CN
X1#]
2S
X1#]
4S
X1#]
5S
X1%]
6S
X1^
20S F•
I 2Lnk
Q X1(]
Q 1.23
E }
OHDCP HdcpO
N 60–
nnnn
40S X2) X2!
•
E } ]
ZA Zpa
E } ]
ZXXX Zpx
Up to 24 alphanumeric characters and hyphen (–). No spaces are allowed, and there is no
distinction between upper and lower case.
0 = light or signal input not detected
1 = digital
0 = no source detected
1 = source detected with HDCP
nnn
nnnn Horizontal xnnnn Vertical
00 (0 hex) through 15 (F hex) ( see
v.vv
Up to 16 alphanumeric characters
xx.x dBm
nnn.n
0 = no sink
FOX II T/R DP 4K Transmitter and Receiver • Remote Control
Additional description
X1@]
Name the transmitter
]
X1^ ]
C Show temperature in degrees Fahrenheit and
Celsius.
X1# X1# X1& X1%
•SigI •Res •HdcpI
The unit responds with the current status
(light detected) of the Rx optical link and the
digital input (signal detected), the resolution, the
HDCP status, the input audio selected, the signal
status of the audio output, the EDID rotary switch
position, and the device type (
] The factory-installed firmware version is 1.23
(sample value only).
X2#] Show HDCP detected on the transmitter loop-
through output.
– ] See the Extron website for part numbers.
nn
Tx X2! Rx X2@]
• •
Reset audio setting to default levels (0 dB gain).
Reset all settings to factory defaults.
1 = light or signal detected
2 = analog
2 = source detected no HDCP present
@xxHz
and the table on page 15 )
item D
1 = HDCP sink
X1@
.
X1$ X1# X1*
•AudI •AudO •EdidMdr
).
TX
2 = non-HDCP sink
]
•TX
22