Table of Contents
Advertisement
Operation
After the transmitter, the receiver, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly, and that all display devices have identical resolutions and refresh rates.
If your problems persist, call the Extron S3 Sales & Technical Support Hotline. See the
contact numbers on the
To take advantage of the various adjustments and test patterns available in the
FOX II T/R DP 4K, you need to connect a computer or other USB-capable device to the
front panel Configuration port or a RS-232 capable device to the rear panel Remote RS-232
port on the unit to be addressed. Operate the connected device using either SIS commands
or the Product Configuration Software (see
Performing resets
The rear panel recessed
loaded firmware for one power cycle (a "mode 1" reset, for comparison with Extron IP Link
products). All user files and settings, such as audio adjustments and video settings are
maintained. A mode 1, firmware, reset is helpful if a firmware upload was interrupted,
resulting in a non-operational unit.
A second reset mode resets all settings to their factory defaults except for the current
firmware level (a mode 5 reset). This reset is the same as performed when you issue the
E ZXXX }
Mode 1 reset
Reset to the factory-installed firmware for one power cycle as follows:
1.
Power off the unit to be reset.
2.
Use a Tweeker or other small item to press and hold the recessed
you apply power to the unit.
3.
When the power up process is complete (the front and rear panel Power LEDs are lit),
release the
The transmitter or receiver returns to the original, factory-installed firmware until the next
time power is removed and restored.
Mode 5 reset
Reset all settings, except firmware, to the factory defaults as follows.
1.
With power applied, use a Tweeker or other small item to press and hold the
button for approximately 9 seconds, until the front or rear panel Power LED blinks three
times.
2.
Release the
button again.
The front and rear panel Power LEDs blink four times during the reset.
last page
of this guide for the Extron office nearest you.
button on both units allows you to revert to the factory
Reset
SIS command (see page 22).
button.
Reset
button and then immediately (within 1 second) press and release the
Reset
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
Remote
Control, beginning on the next page).
button while
Reset
Reset
16
Advertisement
Table of Contents
