Extron electronics FOX II T DP 4K User Manual page 21

Captive screw output connection
See figure 7, below, to properly wire a captive screw output connector, either audio output
on the receiver or return audio output on the transmitter. The connector is included with
transmitter and receiver, but you must supply the audio cable. Use the supplied tie-wrap to
strap the audio cable to the extended tail of the connector.
No Ground Here
Tip
Sleeves
Tip
Do not tin the wires!
No Ground Here
Unbalanced Stereo Output
Figure 7. Captive Screw Connector Wiring for Stereo Audio Output
ATTENTION:
• For unbalanced audio, connect the sleeves to the ground contact. DO NOT
connect the sleeves to the negative (-) contacts.
• Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne PAS
connecter les manchons aux contacts négatifs (–).
NOTE: The length of exposed wires is important (see the RS-232 and IR connector
NOTES on page 11 for more information).
Alarm connection
REMOTE
Pin 1 and pin 2 are
RS-232
ALARM
shorted together when
no light is detected.
Tx Rx G 1 2
Do not tin the wires!
Figure 8. Alarm Connector
NOTE: The length of exposed wires is important (see the RS-232 and IR connector
NOTES on page 11 for more information).
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
13