Extron electronics FOX II T DP 4K User Manual page 16

Fiber optic ports and LEDs
H
WARNING: The FOX II R DP 4K outputs continuous invisible light (Class 1 rated),
which may be harmful to the eyes; use with caution. Plug the attached dust cap
into the optical transceiver when the fiber optic cable is unplugged.
AVERTISSEMENT : Le FOX II R DP 4K émet une lumière invisible en continu
(conforme à la classe 1) qui peut être dangereux pour les yeux, à utiliser avec
précaution Branchez la protection contre la poussière dans l'ensemble
émetteur/récepteur lorsque le câble fibre optique est débranché.
NOTES:
• Ensure that you use the proper fiber cable for your transmitter and receiver
pair. Typically, singlemode fiber has a yellow jacket and multimode cable has an
orange or aqua jacket.
• Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for video,
audio, and RS-232 and IR signal transmission. But, if you connect only one
fiber optic cable:
• The digital video signal output by the receiver is not HDCP-compliant.
• You will not receive RS-232 reports or return audio from the controlled
device.
• To receive responses from the controlled device and for HDCP compliance,
you must install both fiber optic cables.
Tx (required) — For all one-way video, audio, and serial
1
communications from the transmitter to the receiver, connect a
fiber optic cable to the Tx LC connector.
Connect the opposite end of this fiber optic cable to the Rx LC
connector on the FOX II DisplayPort receiver (see
the next page) or to any other compatible Extron FOX II device.
Rx (optional) — For one-way return audio and serial
2
communications from the receiver to the transmitter, connect a
fiber optic cable to the Rx LC connector.
Connect the opposite end of this fiber optic cable to the Tx LC
connector on a FOX II R DP 4K receiver (see
next page) or to any other compatible Extron FOX II device.
Tx Link and Rx Link LEDs — When lit, the link is active (light is
sensed).
Power input — Plug a standard IEC power cord into this connector to connect the
I
unit to a 100 VAC to 240 VAC, 50-60 Hz power source. The lit LED indicates power is
applied.
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
(see figure 2 on page 6) —
figure 3, J
figure 3, J
Tx Rx
OPTICAL
1 1 2 2
on
Transmitter
to
Receiver
on the
Tx Rx
OPTICAL
8