Extron electronics FOX II T DP 4K User Manual page 18

DisplayPort output port
K
video display to this DisplayPort connector.
Audio output ports
— These connectors output the transmitted,
L
unamplified, line level analog audio (see
page 12 to wire these connectors).
NOTE: If embedded digital audio is present on the DP connector, these analog
audio connectors do not output audio unless forced to so by an
(see page 21).
TRS jack connector — Connect an audio device, such as an audio amplifier or
powered speakers to this 3.5 mm TRS connector.
Captive screw output connector — Connect an audio device, such as an audio
amplifier or powered speakers to this 5-pole, 3.5 mm captive screw connector.
Audio Return In port
M
to this 3.5 mm, 5-pole captive screw connector for return to the transmitter
(see Audio connections
Over Fiber RS-232 and IR port
N
a modulated or unmodulated IR signal, or both to this 3.5 mm, 5-pole
captive screw connector for bidirectional RS-232 and IR communication
(see RS-232 and IR connections
NOTES:
• If you connect only one fiber optic cable (see
receive RS-232 or IR reports from the controlled device. To receive responses
from the controlled device, you must install two fiber optic cables.
• The FOX II T/R DP 4K can pass RS-232 commands and responses at rates up
to 115200 baud.
Remote RS-232 port
O
device, such as a computer or touch panel control, via this 3-pole captive
screw connector (see RS-232 and IR connections
See Remote Control
Alarm port — For remote monitoring of the status of the Rx fiber optic link,
P
connect an external control system or locally-constructed or furnished
monitoring device to the receiver via the two rightmost poles (1 and 2) of this
5-pole captive screw connector. When the receiver does not detect a light
link on fiber cable Rx, pin 1 and pin 2 of this port are shorted together. (see
connection on page 13 to wire this connector).
Power input — Plug a standard IEC power cord into this connector to connect the
Q
unit to a 100 VAC to 240 VAC, 50-60 Hz power source. The lit LED indicates power is
applied.
FOX II T/R DP 4K Transmitter and Receiver • Installation and Operation
(see figure 3 on the previous page) — Connect a
Audio connections
— Connect a balanced or unbalanced audio input
to wire these connectors).
— Connect a serial RS-232 signal,
on page 11 to wire the connector).
— For serial control of the receiver, connect a host
on page 17 for SIS commands.
DISPLAYPORT
AUDIO
on
SIS command
RETURN IN
RS-232
Tx Rx
item H , on page 8), you will not
REMOTE
RS-232
to wire this connector).
Tx Rx G
REMOTE
RS-232
Tx Rx G
Alarm
L R
AUDIO
L R
IR
G Tx Rx
ALARM
1 2
ALARM
1 2
10