Setting Up The Lightwave Component - Keysight Technologies N4373D User Manual

Setting Up the Lightwave Component Analyzer
C A U T I O N
Keysight N4373D Lightwave Component Analyzer, User's Guide
The network analyzer and Lightwave Component Analyzer
module are assembled as one analyzer unit. Lifting this instrument
requires two people using proper lifting techniques. For the
combined weight, please consult the specifications ("General
Characteristics" on page 155, and the user's documentation for
the network analyzer).
1. Unpack and inspect the contents as described in "Unpacking
the Lightwave Component Analyzer" on page 24.
2. Skip to step 3. for options 2x0, 4x0, and 2x9, 4x9, if the PNA
does not include a configurable test set.
a On the receiver
side (Port 2 for
options 2x1,
2x2, 2x9 (if
applicable);
Port 4 for
options 4x1,
4x2, 4x9 (if
applicable)),
pull the cable
guard out from
the front panel.
Use the 8 mm
b
torque wrench
from the
calibration kit
(0.90 N-m/8 lb.-
in, part number
8710-1765) to
remove the top
two rigid cables
from the
connectors.
Getting Started
29