Getting Started
Setting Up the Lightwave Component Analyzer
CAU T ION
CAU T ION
CAU T ION
24
The network analyzer and Lightwave Component Analyzer
module are assembled as one analyzer unit. Lifting this
instrument requires two people using proper lifting
techniques. For the combined weight, please consult the
specifications ("General Characteristics" on page 144, and
the user's documentation for the network analyzer).
1. Unpack and inspect the contents as described in "Unpacking
the Lightwave Component Analyzer" on page 22.
2. Connect the testport cables
(Partnumber 8120-8862)
from port 1 on the network
analyzer to port A on the
optical test set and from
port 2 on the network
analyzer to port B on the
test set.
3. Remove the dust cap from
the Optical Output.
If you are using a patchcord with a straight and angled
connectors, make sure you only connect the angled
connector (green) to the optical test set.
4. Remove the dust cap from the optical patchcord.
5. Connect the optical patchcord.
6. Repeat step 3. to step 5. for the optical input.
Always use patchcords to connect to your DUT. This
protects the connectors of the optical test set, by
minimizing the number of connector changes.
Keysight N4374B Lightwave Component Analyzer, User's Guide