Table of Contents
Advertisement
2
Setting Up the Instrument
Setting Up the Lightwave Component Analyzer
30
1
Unpack and inspect the contents as described in
Lightwave Component Analyzer
2
Skip to step 3. if the PNA does not include a configurable test set.
•
On the receiver side (Port 2 on a 2-port PNA, Port 4 on a 4-port
PNA), pull the cable guard off the front panel.
•
Use the 8 mm torque wrench from the calibration kit (0.90 Nm/ 8
lb.-in, part number 8710-1765) to remove the top two rigid cables
from the connectors.
•
Re-connect the rigid cables in a vertical position and fasten them
using the same torque wrench as before.
Keysight N4373E Lightwave Component Analyzer Setup Guide
Unpacking the
on page 22.
Advertisement
Table of Contents
