Zcu216 Ft4232Hl Connectivity; Gpio (Mio 22-23); Pmu Gpi (Mio 26); Pmu Gpo (Mio 32-37) - Xilinx Zynq UltraScale+ ZCU216 User Manual

For more information on the FT4232HL, see the
website.
The detailed RFSoC connections for the feature described in this section are documented in the
ZCU216 board XDC file, referenced in

GPIO (MIO 22-23)

PS-side pushbutton SW1 is connected to MIO22 (pin U1.AL27). PS-side LED DS1, physically
placed adjacent to the pushbutton, is connected to MIO23 (pin U1.AM27).

PMU GPI (MIO 26)

PS-side MIO 26 is reserved as an input to the PMU for indicating a warm boot. PS bank 501
MIO26 (U1.A34) is connected to the I2C0 U15 TCA6416A bus expander (port P02 U15.6)
through level-shifter U27. Refer to the Zynq UltraScale+ Device Technical Reference Manual
(UG1085) for details about the PMU interface.

PMU GPO (MIO 32-37)

The platform management unit (PMU) within the Zynq UltraScale+ RFSoC signals power domain
changes using the PMU output pins for deep-sleep mode. The Zynq UltraScale+ RFSoC PMU
GPO pins are connected to inputs of the MSP430 system controller through the TXS0108E level-
shifter U37. The RFSoC U1 Bank 501 and MSP430 U38 pin numbers are listed in the following
table.
UG1390 (v1.1) July 10, 2020
ZCU216 Board User Guide
Figure 9: ZCU216 FT4232HL Connectivity
Future Technology Devices International Ltd.
Appendix B: Xilinx Design
Chapter 3: Board Component Descriptions
Constraints.
Send Feedback
www.xilinx.com
36