Colp Connected Line Identification Report; Cr Data Service Report; Cring Distinctive Ring - Nokia 30 GSM Connectivity Terminal At Command Manual

15.3.2 +COLP Connected line identification report

Format Description
+COLP: Given when +COLP=1 and a number is received from the network when MO call established
<number>,
<type>
The +COLP intermediate result code is given after the possible +CSSI result code. This
result code is enabled and disabled with the +COLP command.
Defined values
<number> string type phone number of the format specified by <type>
<type> type of address octet in integer format (refer GSM 04.08 subclause 10.5.4.7):
129
145

15.3.3 +CR Data service report

Format Description
+CR: REL Given when +CR=1 and a data call is established; informs about the type of data call being
ASYNC established
The +CR intermediate result code is given after a possible +COLP result code during an MO
data call setup. During an MT data call setup, this is the first intermediate result code. Note
that this result code should replace the CARRIER result code (when X5 is set). This result
code is enabled and disabled with the +CR command.

15.3.4 +CRING Distinctive ring

Format Description
+CRING: Given when +CRC=1 and incoming MT call (no active or held calls in ME)
<type>
This result code is enabled and disabled with the +CRC command.
NOTE: +CRING replaces the V.25ter RING result code.
unknown/telephony
international/telephony
86/107