Call Control Commands; V.25Ter; D Dial - Nokia 30 GSM Connectivity Terminal At Command Manual

6.

CALL CONTROL COMMANDS

6.1 V.25TER

6.1.1 D Dial

Command
Execute D<dial-string>
The original description of the D command is specified in the V.25ter standard, but
implementation is according to the modifications specified in GSM 07.07. Before one of the
above codes can be returned, some of the following may precede it: +CSSI, +COLP, +CR (or
CARRIER), +DR, or +ILRR (in that order). The dial command is also used to control
alternating mode calls (see GSM 07.07 section 6.6 and annexes E and F).
NOTE: The +VTS command or comma modifier (i.e. "ATD,1234"; in this case the first comma
does not cause a pause) can be used to send DTMF digits.
Possible Numeri
verbose result c (V0)
codes (V1)
BLACKLISTED 14
BUSY 7
CONNECT 1
CARRIER 16
CONNECT 1200 5
CONNECT 2400 10
CONNECT 4800 11
CONNECT 9600 12
CONNECT 14400 17
CONNECT 19200 18
CONNECT 28800 19
CONNECT 38400 20
DELAYED 13
ERROR 4
NO ANSWER 8
NO CARRIER 3
OK 0
Description
Calls to the number are forbidden until
manual reset
Called party is busy
Data/fax call established; rate 300 bps (or X
forbids rate display)
Data/fax call established; rate 1200 bps
Data/fax call established; rate 2400 bps
Data/fax call established; rate 4800 bps
Data/fax call established; rate 9600 bps
Data call established; rate 14400 bps
Data call established; rate 19200 bps
Data call established; rate 28800 bps
Data call established; rate 38400 bps
Calls to the number are temporarily
forbidden
Command cannot be carried out
Called party does not answer
Call could not be established
Command aborted or voice call started with
semicolon character
17/107