T Select Tone Dialling - Nokia 30 GSM Connectivity Terminal At Command Manual

<dial-string> characters
V.25ter dialling digits
V.25ter modifiers
V.25ter semicolon
GSM 07.07 modifiers
De facto
NOTE: I is the only case-sensitive dial string character.
Direct dialling
command
D>mem<n>[i/I][G][;]
D><n>[i/I][G][;]

6.1.2 T Select tone dialling

Command
Execute T
The T command is ignored. Implementation is according to GSM 07.07 section 6.18.
Values Description
0123456789+#* Accepted as valid digits (* and # can only be at the
beginning)
ABCD Cause ERROR
, In the case of a voice call: originate call to the number
preceding a comma, wait for a remote answer, pause for a
length specified with the S8 register, and send numbers
after the comma as DTMF digits; further commas cause a
pause specified with the S8 register (all commas are
ignored in the case of data call)
T P ! W @ Accepted but ignored
; Voice call originating (must be the last character of
command line)
> Direct dialling from the phonebook (must be the first
character after D) (see next table)
i Allow calling line ID presentation for this call
I Restrict calling line ID presentation for this call
G Control CUG information for this call; use +CCUG values
L Redial the number last dialled
Description
Originate call to the phone number found in the location <n> in a specific
memory mem, which is one of the two letter memory abbreviations as
returned by +CPBS=? (without double quotes); the location range can be
queried with +CPBR=?; note that in the case of a SIM ADN memory
(SM), D>SIM<n> should also be accepted (due to inconsistency in
07.07)
Originate call to the phone number in memory location <n>; the memory
selected with +CPBS is used
+cme
error
X
X
18/107