Colp Connected Line Identification Presentation - Nokia 30 GSM Connectivity Terminal At Command Manual

Defined values
<n> sets the adjustment for outgoing calls:
0
1
2
<m> shows the subscriber CLIR service status in the network:
0
1
2
3
4

7.7 +COLP CONNECTED LINE IDENTIFICATION PRESENTATION

Command
Set +COLP=<n>
Read +COLP?
Test +COLP=?
The +COLP command refers to the GSM supplementary service COLP (Connected Line
Identification Presentation) that enables a calling subscriber to get the connected line identity
(COL) of the called party after setting up a mobile-originated call. The command enables or
disables the presentation of the COL. It has no effect on the execution of the COLR
supplementary service in the network.
When enabled (and the called subscriber allows), the +COLP: <number>, <type>
intermediate result code is returned before any +CR or V.25ter responses.
The read command gives the status of <n> and triggers an interrogation of the provision
status of the COLP service according to GSM 02.81 (given in <m>).
The test command returns the supported values.
Defined values
<n> sets/shows the result code presentation status in the Nokia 30:
0
1
the presentation indicator is used according to the subscription of
the CLIR service
CLIR invocation
CLIR suppression
CLIR not provisioned
CLIR provisioned in permanent mode
unknown (e.g. no network, etc.)
CLIR temporary mode presentation restricted
CLIR temporary mode presentation allowed
Response Default
0
+COLP: <n>,<m>
+COLP: (0,1)
disable
enable
40/107