Cgact Pdp Context Activate Or Deactivate; Cgdata Enter Data State - Nokia 30 GSM Connectivity Terminal At Command Manual

13.6 +CGACT PDP CONTEXT ACTIVATE OR DEACTIVATE

Command
Set +CGACT= [<state> [,<cid>[,<cid>[,..]]]
Read +CGACT?
Test +CGACT=?
Optional. The execution command is used to activate or deactivate the specified PDP
context (s).
Defined values
a numerical parameter which specifies a particular PDP context definition.
<cid>

13.7 +CGDATA ENTER DATA STATE

Command
Execute +CGDATA=<L2P>[,<cid>]
Test
Optional. 07.60 section 10.2.6. Causes the MT to perform whatever actions are necessary to
establish communication between the TE and the network using one or more GPRS PDP
type(s).
If the user, however, uses a non-existent <cid> value, even if it is within a valid range, DCE
shall issue an ERROR result code in response to such an attempt. See +CGDCONT.
Defined values
<L2P> "PPP"
<cid> 1...2
NOTE: GPRS Phase 1 does not support mobile-originated context modification.
Response
+CGACT: <cid>, <state>
[<CR><LF>+CGACT: <cid>, <state>
[...]]
+CGACT: (0-1)
Response
CONNECT
NO CARRIER
+CGDATA: ("PPP")
Description
Enter data state
Data state cannot be entered
79/107