Initialising The Nokia 30; Making A Data Call With Nokia 30; Sending An Sms From A Terminal Or Other Similar Application - Nokia 30 GSM Connectivity Terminal At Command Manual

17.2 INITIALISING THE NOKIA 30

Command from the DCE
AT&F<CR>
AT+IFC=1,1<CR>
AT&D0<CR>

17.3 MAKING A DATA CALL WITH NOKIA 30:

ATD+358705966200<CR>

17.4 SENDING AN SMS FROM A TERMINAL OR OTHER SIMILAR APPLICATION

There are two different modes – text mode and PDU (Protocol Data Unit) mode – for
handling short messages. The default mode of the Nokia 30 is the PDU mode (+CMGF=0).
Text mode is easier to understand than the PDU mode.
AT+CMGF=0<CR>
AT+CMGS=29<CR>
>0011000C915358508181420000A7
1154747A0E4Acf41f4f29C9E769F41
21
Response Explanation
from the
Nokia 30
- Set to factory-defined configuration.
OK Previous command was successful
- Set the flow control to SW flow
control; the default is HW flow control
(2,2)
OK Previous command was successful
- Ignore DTR changes
OK Previous command was successful
- Start connection by dialling the
preferred number
CARRIER The Nokia 30 has a data connection
to the GSM infrastructure
CONNECT The connection to the preferred
number is established and the
application can start sending data
- Set the Nokia 30 to GSM 07.05 SMS
PDU mode (default).
- Send the message to the defined
phone number. The service number is
not a mandatory field in the PDU
structure. This example does not have
the SMSC number.
102/107