Te-Ta Interface Commands; V.25Ter; S3 Command Line Termination Character; S4 Response Formatting Character - Nokia 30 GSM Connectivity Terminal At Command Manual

4.

TE-TA INTERFACE COMMANDS

4.1 V.25TER

4.1.1 S3 Command line termination character

Command
Set S3=<n>
Read S3?
The S3 command sets the decimal IA5 value of command line termination used by the DCE
as a part of the header, trailer and terminator for result codes and information text, along with
the S4 parameter (see the description of the V command for usage).
If the value of S3 is changed on a command line, the result code issued in response to that
command line will use the new value of S3. For example, if S3 was previously set to 13 and
the command line "ATS3=50" is issued, the result code issued will use the character with the
ordinal value 50 (IA5 3/2) in place of the CR.

4.1.2 S4 Response formatting character

Command
Set
S4=<n>
Read S4?
The S4 command sets the decimal IA5 value of the character generated by the DCE as a
part of the header, trailer and terminator for result codes and information text, along with the
S3 parameter (see the description of the V command for usage).
If the value of S4 is changed in a command line, the result code issued in response to that
command line will use the new value of S4.

4.1.3 S5 Command line editing character

Command
Set
S5=<n>
Read S5?
Response <n> values
0..127 (default 13)
<n> 000..127
Response <n> values
0..127 (default 10)
<n> 000..127
Response <n> values
0..127 (default 8)
<n> 000..127
6/107