Cnmi New Message Indications To Te - Nokia 30 GSM Connectivity Terminal At Command Manual

10.10

+CNMI NEW MESSAGE INDICATIONS TO TE

Command
Set +CNMI=<mode>,<mt>,
<bm>,<ds>,<bfr>
Read +CNMI?
Test +CNMI=?
The +CNMI command defines the procedure for indicating the receiving of new messages
from the network to the TE when the TE is active; e.g. DTR signal is ON. If the TE is inactive
(e.g. DTR signal is OFF), message receiving should be carried out as specified in GSM
03.38.
<mode> controls the processing of unsolicited result codes specified within this command,
<mt> sets the result code indication routing for SMS-DELIVERs, <bm> for CBMs and <ds>
for SMS-STATUS-REPORTs. <bfr> defines the handling method for buffered result codes
when <mode> 1 or 2 is enabled.
The test command gives the supported setting values.
Defined values
<mode> The setting only affects unsolicited result codes specified within this command:
0 Buffer unsolicited result codes in the Nokia 30. If the Nokia 30 result code
buffer is full, the oldest indications will be discarded and replaced with the
newly received indications.
1 Discard indication and reject new received message unsolicited result
codes when the control link is reserved (e.g. in online data mode).
Otherwise, forward them directly to the TE.
2 Buffer unsolicited result codes in the Nokia 30 when the control link is
reserved (e.g. in the online data mode) and flush them to the TE after
reservation. Otherwise forward them directly to the TE.
NOTE: The result code buffer is in volatile memory, messages may get lost if
the Nokia 30 is switched off before the codes are sent to TE.
<mt> The rules for storing received SMs depend on the data coding scheme (refer to
GSM 03.38), preferred memory storage (+CPMS) setting and this value:
0
Response
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
+CNMI: (0-2),(0-3),(0,2,3),(0-2),(0,1)
No SMS-DELIVER indications are routed to the TE.
If SMS-DELIVER is stored in the Nokia 30, an indication of the
memory location is routed to the TE using an unsolicited result
code: +CMTI: <mem>, <index>
Default +cms error
0,0,0,0,0 X
60/107