Download Print this page
   

Advertisement

1. ANALOG FAX QUICK GUIDE FOR THE NOKIA 32 TERMINAL
The Nokia 32 terminal supports group 3 analog fax connection according to ETSI TS 100931 v8.0.1.
standard with maximum of 9600 bit/s. The analog fax feature is an addition to the product functionality
and is supported with the following or newer software:
8.75 TME-3 (Nokia 32 GSM module)
5.03 DTX-3 (Nokia 32 application module)
1.1 Connecting analog fax to Nokia 32 terminal
Connect the analog fax to the trunk connector of the Nokia 32 terminal.
1.1.1 Connecting cable
Use a 2-wire cable between the analog fax machine and the Nokia 32 terminal. If you use a 4-pin RJ-11
cable, connect only the pins 2 and 3, as shown in picture 1. If you use a 6-pin RJ-11 cable, connect only
the pins 3 and 4, as shown in picture 2. In both pictures, the coloured lines represent the connection to
the pins in the trunk connector of the Nokia 32 terminal.
Note that even though RJ-11 connectors have 4 or 6 pins, only 2 wires can be connected, as shown
below.
NOKIA 32 ANALOG FAX
QUICK GUIDE
1 (3)

Advertisement

   Also See for Nokia 32

   Related Manuals for Nokia 32

   Summary of Contents for Nokia 32

  • Page 1

    1.1.1 Connecting cable Use a 2-wire cable between the analog fax machine and the Nokia 32 terminal. If you use a 4-pin RJ-11 cable, connect only the pins 2 and 3, as shown in picture 1. If you use a 6-pin RJ-11 cable, connect only the pins 3 and 4, as shown in picture 2.

  • Page 2

    LED 3 blinks green. 1.4 Using Nokia 32 terminal in permanent analog fax mode You can set the Nokia 32 terminal to permanent analog fax mode. In this mode, all calls are handled as fax calls. When the Nokia 32 terminal is in permanent fax mode, the actual GSM voice channel enhancements are not in use and thus the voice quality may be poor.

  • Page 3

    Typically when a SIM card is activated for mobile services, only the voice and data services are activated. However, when using the analog fax feature of the Nokia 32 terminal, you must ask the operator to activate the fax service both for sending and receiving faxes.

Comments to this Manuals

Symbols: 0
Latest comments: