Car-O-Liner CTR9 Instruction Manual page 16

Car-O-Liner Group AB CTR9
IMPORTANT! Before starting the welder again, fit the electrode cap and
fill upp with cooling liquid, see section 3.7 Filling of cooling liquid.
IMPORTANT! If the thermal breaker has switched off the welder,
please contact Car-O-Liner authorized service personnel.
IMPORTANT! Do not use water that is salt, brackish or rich in lime.
If there is any uncertainity regarding the quality of the water, use destilled
water.
IMPORTANT! If the heater is used in temperatures below freezing point,
Car-O-Liner´s recommended antifreeze agent must be used. If the machine is
used in temperatures below -10°C, a higher concentration of High-Tech
Protection Fluid must be used.
IMPORTANT! It is the responsibility of the owner to ensure that the work
place is well ventilated with a local fume extractor.
IMPORTANT! The shape of the caps is essential and the electrode caps
must be changed regularly to maintain good welding results! The radius of a
new cap is R15.
IMPORTANT! Never use water jet, detergents, solvents, thinners or
benzene when washing the welder since they can damage the welder.
IMPORTANT! Risk for damage to materials close to the weld, e.g to glass
or textiles.
IMPORTANT! Ensure that all electrical equipment within the welding
object is disconnected. Risk for interference.
SAVE THESE INSTRUCTIONS!
16
49023, EN - rev. 4, 2020-01