Car-O-Liner CTR9 Instruction Manual page 107

CTR9
Water flow off
Over temperature
Control voltage error
Fan error
System error
49023, EN - rev. 4, 2020-01
- The cooling water flow is not sufficient.
- The welder is overheated.
- Missing supply voltage or value below
specified level.
- Fan malfunction.
- Welder internal error.
Car-O-Liner Group AB
- Make sure that the cooling water pump
is not switched OFF.
- Wait and try again when "Over tempera-
ture" message disappears.
- Check cooling water level.
Add cooling water if level is low.
- Contact authorized Car-O-Liner
service personnel.
- Contact authorized Car-O-Liner
service personnel.
- Contact authorized Car-O-Liner
service personnel.
107