Car-O-Liner CTR9 Instruction Manual page 12

Car-O-Liner Group AB CTR9
WARNING! Sparks and welding spatter from the spot welder can damage
your eyes and face. To avoid risk for personal injuries, always use a visor.
WARNING! Make sure that you know where the fire extinguishing
equipment is. Risk for injuries.
WARNING! The tools or electrodes may be hot. Risk for burning injuries.
WARNING! It is very important to turn the handle firmly to fasten the
yoke.
WARNING! All service and maintenance must be carried out by Car-O-
Liner service personnel and service support. Risk for electrical shock.
WARNING! Do not remove any covers of the welder. Risk for electrical
shock.
WARNING! Unplug the welder from the wall outlet before servicing,
cleaning or maintenance. Risk for electrical shock.
WARNING! Ground Fault Circuit Interrupter (GFCI) must be used.
WARNING! Don't remove any covers when cleaning the welder. Risk for
electrical shock.
WARNING! Before plugging the mains plug into the on-site socket, make
sure that it is appropriate. If not, do not put the machine into service.
WARNING! Do not exceed the recommended value (daN) on the safety
sign on the yoke. Risk for damage to the equipment.
WARNING! Always use the handle to move the welder. Do not pull the
cable or the tong to move the welder. The welder might tip, causing personal
injuries or serious damage to the welder. When moving the machine, the
C-Tong must be fixed at the intended holder (on the side of the machine)
and must not hang on the support arm. A swinging tong might cause
personal injuries or material damage.
WARNING! Risk of crushing (moving electrodes).
12
49023, EN - rev. 4, 2020-01