Turning Off Cooling Water When Changing Electrodes - Car-O-Liner CTR9 Instruction Manual

CTR9
6.8

Turning off cooling water when changing electrodes

49023, EN - rev. 4, 2020-01
When you change electrodes you need to turn off the cooling water pump in
order to prevent water from pouring out from the yoke.
1. Press the "Water flow" button to turn OFF the cooling water pump.
2. Red box with "Water flow off" is shown.
3. After changing the electrodes, press the "Water flow" button again
to turn ON cooling water pump before you start welding!
IMPORTANT! It is not possible to start welding before cooling water
pump flow is turned on.
Car-O-Liner Group AB
81