Grounding Risk - Car-O-Liner CTR9 Instruction Manual

CTR9

3.4.1 Grounding risk

49023, EN - rev. 4, 2020-01
CTR9 has a grounded welding tong. Therefore the welding object must be
isolated from ground. All other work with grounded equipment shall not be
performed at the same time as welding. Always use Ground Fault Circuit
Interruptor (GFCI) to avoid stray current damages on the welder.
Figure 3.1 Grounding risk
WARNING! A high sensitive Ground Fault Circuit Interrupter (GFCI)
must always be used on the mains to protect the welder from stray current.
Risk of damage to the welder.
Car-O-Liner Group AB
27