Car-O-Liner CTR9 Instruction Manual page 14

Car-O-Liner Group AB CTR9
WARNING! This Class A equipment is not intended for use in residential
locations where the electrical power is provided by the public low-voltage
supply system. There may be potential difficulties in ensuring electro-
magnetic compatibility in those locations, due to conducted as well as
radiated disturbance.
WARNING! The C-Tong must be held correctly during welding.
Risk of crushing (moving electrodes).
WARNING! A high sensitive Ground Fault Circuit Interrupter (GFCI)
must always be used on the mains to protect the welder from stray current.
Risk of damage to the welder.
WARNING! Tighten the yoke locking lever fully to ensure correct locking
of the yoke. Risk of personal injuries or material damage.
IMPORTANT! For good cooling efficiency, never operate the welder
without connecting it to the compressed air network.
IMPORTANT! Read this manual carefully to become familiar with the
proper operation of the welder. Do not neglect to do this as improper
handling may result in personal injury and damage to the equipment.
IMPORTANT! The CTR9 may only be used by qualified personnel. The
user of the welder must have knowledge of spot welding and of alignment of
collision-damaged vehicles.
IMPORTANT! Do not turn off the welder while cooling is activated!
IMPORTANT! If the thermal breaker has switched off the welder, please contact Car-O-Liner authorized service personnel.
IMPORTANT! It is the responsibility of the owner to ensure that the
equipment has been installed as specified in the instructions provided. It is
also the owner's responsibility to ensure that the welder is inspected in
accordance with applicable regulations before it is used.
IMPORTANT! The compressed air must be filtered and free from oil and
moisture. Use air filter/water separator.
IMPORTANT! Maximum air pressure 10 bar (145 PSI). Recommended air
pressure between 5 bar (73 PSI) and 10 bar (145 PSI).
14
49023, EN - rev. 4, 2020-01