Car-O-Liner CTR9 Instruction Manual page 15

CTR9
49023, EN - rev. 4, 2020-01
IMPORTANT! The recommended air pressure shall not normally be
changed!
IMPORTANT! It is important to ground the welding object to obtain
quality weld nuggets.
IMPORTANT! When not in use, be sure to place the multi-function gun
and the ground connector so that they do not make electrical contact. Risk
for short circuit.
IMPORTANT! Be sure to begin welding at the point farthest from the
ground connector.
IMPORTANT! Make sure to connect the ground connector to an area
where the inner body sheet is level and not curved.
IMPORTANT! For the sake of the environment, it is important that the
equipment is dismantled in an environmentally friendly way.
IMPORTANT! All straight electrodes have an inner tube that must be
fitted to provide sufficient cooling.
IMPORTANT! It is not possible to start welding before cooling water
pump flow is turned on.
IMPORTANT! The machine must be securely strapped and the front wheel
roll brakes must be locked in transport mode. The C-Tong must be placed on
the pallet.
IMPORTANT! Single sided spot welding is not permitted on supporting
frameworks of a vehicle. It is only permitted for cosmetic purposes.
IMPORTANT! The outer sheet must be the thinnest sheet when
performing single sided spot welding. The thickness of the outer sheet to be
welded must be less than 1.5 mm, and the thickness of the inner sheet must
be less than 2 mm
IMPORTANT! When not in use, be sure to place the multi-function gun
and the ground connector so that they do not make electrical contact. Risk
for short circuit.
Car-O-Liner Group AB
15