Transport - Car-O-Liner CTR9 Instruction Manual

CTR9

3.14 Transport

49023, EN - rev. 4, 2020-01
When moving the machine to a new workplace, release the roll brakes (1)
and then pull or push the machine by the handle
cles such as dispersed cables and unevenness of the floor!
When transporting the welding machine to another location,
power supply and compressed air supply must first be disconnected.
Use a ramp (3) to roll the machine on to the pallet. Lock the roll brakes (1).
Place the C-Tong on the pallet (4), not on the C-Tong hanger. Lift the pallet
with a fork lift. The welder must be securely strapped to the pallet before
transport, in the same way as when it was delivered from the manufacturer!
Before transporting a welder that is filled with decalcified water and Car-O-
Liner High-Tech Protection Fluid at temperatures below -5°C, completely
drain the cooling liquid. Fill up the system with 2 L pure concentrated High-
Tech Protection Fluid and start up the machine. Then let the fluid circulate
together with the remaining cooling liquid in the system.
The manufacturer shall not be liable for any damage resulting from improper
transportation!
IMPORTANT! The machine must be securely strapped and the front wheel
roll brakes must be locked in transport mode. The C-Tong must be placed on
the pallet.
Car-O-Liner Group AB
(2). Pay attention to obsta-
43