Configuring Ethernet Ports - Omni 4000 Series Installation Manual

4.3.2 Configuring Ethernet Ports

Initially, every OMNI 4000/7000 flow computer will appear with these default IP addresses:
•
10.0.0.1 for Ethernet Port 1
•
10.0.0.2 for Ethernet Port 2 (of each Dual Ethernet [DE] module installed)
You must change this IP address to one that is unique and appropriate for your network,
especially if you have multiple OMNI flow computers installed.
Use a valid IP Address and Netmask combination; for example, 10. 10. 90.250 and
255.255.0.0. Check with your Network Administrator for more details about IP
addresses.
Unlike Serial ports, Ethernet ports are only accessible through Ethernet modules. The following
selections are available from the front panel for Ethernet ports located on the Ethernet modules:
•
Ethernet (DE) Module 1 for ports 21-28
•
Ethernet (DE) Module 1 for ports 41-48
•
Ethernet (DE) Module 2 for ports 61-68
•
Ethernet (DE) Module 2 for ports 81-88
Some Ethernet port selections may not appear on the screen, as this is dependent on what
Ethernet modules are installed in the flow computer.
To configure an Ethernet port, follow these instructions:
1. From the Home screen, select Utilities,
and then press OK.
2. On the Utilities screen, select
Communications and press OK.
4-10
OMNI 4000/7000 Installation Guide – Rev H
Configuration