Configure Ports - Omni 4000 Series Installation Manual

3. Click the Browser button (the ellipses) to
the right of the Assign field to open the
OMNI Database Browser and make a
database variable assignment.
Each analog output channel must
be assigned a user-selected
database variable to be output
through the selected analog
output. The selected variable will
typically be a process variable
that is represented in engineering
or percentage units.
4. Choose the register you want to assign to
the output; then click Select to assign it.
After you have finished making your
5.
selections and entering parameters for this
output, click the Apply button to save the
configuration.
Expand the next module in the tree and
6.
select Analog Output. Repeat Steps 2
through 5 for each module, as needed.

4.10.4 Configure Ports

Depending on the modules installed in the flow computer, the ports may have already been set
up and configured (Sections 4.3.1 and 0). However, you can now use OMNICONNECT™ to edit
the settings for those ports or configure any ports that have not been configured up until
this point.
CAUTION: Do not edit the settings for an active serial or Ethernet port that you are
currently connected to as this could disrupt the active connection to the flow
computer.
You cannot edit the settings for the front panel USB or the CPU USB.
4-61
OMNI 4000/7000 Installation Guide – Rev H
Configuration