Omni 4000 Series Installation Manual page 69

OMNI 4000/7000 Installation Guide – Rev H
4. To access Serial Ports on the Ethernet
Modules, one additional step is needed:
a. Select the Ethernet Module you
want to edit and press OK.
b. Select the Serial Port (not the
Ethernet port) to edit and press OK.
5. Use the Up and Down arrow keys to
navigate to the required settings. Press OK
or Enter to activate the field for editing.
Contact your IT or Network
Administrator for help with your
COM port parameters to whatever
serial device is being connected to
the flow computer.
6. a. Use the Up and Down arrow keys
to select the option that matches the
communication parameters on the flow
computer to your PC COM port.
b. Press OK or Accept to accept the
changes before moving to the next
setting.
Use the Numeric Keypad to update
the Modbus ID.
7. Use the Pg Up and Pg Down function key
to navigate to all settings.
After the settings have been configured,
8.
verify that the serial cable is correctly
installed (Section 3.7.4
Serial Module).
4-9 Configuration