Process I/O Module Configuration
In these instructions, we configure a new A module. Configuration steps for other
types of modules are similar, but the specifics of setup will be different, depending
on the module.
To configure Process I/O points, follow these instructions:
1.
Click the Configure button in the Home
ribbon to open the Configure tree in the
left panel.
a. Click the + to expand the OMNI I/O
2.
section in the tree.
b. Select and expand Process I/O;
then expand the module (in this
example, A-1).
c. Select Process Inputs to display
the configuration settings on the
screens to the right.
Along the top of the screen are tabs for
3.
each process input that is available on the
module. Fill in the required information in
these screens.
Press F1 to access
OMNICONNECT Help for
assistance.
4.
After you have finished making your
selections and entering parameters for this
input, click the Apply button to save the
configuration.
4-59
OMNI 4000/7000 Installation Guide – Rev H
Configuration