Omni 4000 Series Installation Manual page 35

12. Attach each provided Ferrite clamp to an
I/O cable(s):
a. Carefully open the cover latch of a
clamp and position the clamp around
I/O Cable A.
b. Secure the clamp cover latch.
c. Wrap the clamp with the provided
non-static tape two times while
removing the tape liner backing.
If you are installing the OMNI 7000, repeat
for I/O Cable B.
CAUTION: Do not remove the Ferrite clamp from the cable assembly after the clamp
is attached. The ferrite clamp provides radio frequency interference suppression for
electromagnetic compatibility and measuring instrument directives (MID) compliance.
13. Mount the back panel using the
factory-supplied mounting screws and
standoffs.
The OMNI 4000 (and the OMNI
7000 with the short-extended back
panel) uses 5 screws. The OMNI
7000 with the standard extended
back panel uses 12 screws.
The OMNI 4000 back panel contains 6 holes, but only 5 can be used to mount the
back panel because the 64-pin ribbon cable from the motherboard must be routed
under the back panel.
14. To complete installing the OMNI 4000 I/O
cable, connect I/O Cable A to the
motherboard in the chassis at CONN A.
3-13
OMNI 4000/7000 Installation Guide – Rev H
Installation