To configure ports, follow these instructions:
1.
Select Ports in the Configure tree in the
left panel and expand the list to see all the
different modules and ports on the
flow computer.
2.
Select a serial port in the tree to display
its settings on the right screen.
If the port was previously configured,
these settings will already be established.
Verify the settings in the flow computer.
a. If the settings do not need
adjusting, go to Step 4.
b. If the settings need to be
adjusted, go to Step 3.
If the port was not previously configured
3.
or does not match the settings in the flow
computer, make the required selections in
the screens on the right to configure the
port.
Click Apply after you complete each
screen to save your changes.
Press F1 to access
OMNICONNECT Help for
assistance.
4.
Continue selecting each serial port as you
move down the Configure tree to either:
a. Verify its settings (Step 2).
b. Configure its settings (Step 3).
4-62
OMNI 4000/7000 Installation Guide – Rev H
Configuration