Table of Contents
Advertisement
Available languages
Available languages
3
Installation
3.1
Fastening the control unit
Make sure that the control unit is disconnected from the power supply during installation work.
•
Select the mounting position making sure that:
– there is a safety socket in the direct vicinity of the control units.
– The connecting cable from the wastewater pump, backwater flap
and level sensors can be installed correctly and routed to the control
unit.
– The control unit can be fastened safely and sufficiently.
•
Open the housing, to do this loosen the two screws <29> (anti-
clockwise) and open the housing cover.
•
Fit the housing at the designated place and fit all two fastening screws
(drilling template included in the scope of delivery). Make sure that the
gap <4> between the screw heads and fastening area is approx. 3 to
4 mm
•
Suspend the control unit on the two fastening screws <5> and press
down lightly
•
L = 254 mm see drilling template (373-123)
2019/04
29
37 / 168
Fig. [5]
4
L
5
Fig. [6]
Advertisement
Chapters
Table of Contents
