Display And Control Panel - Kessel Comfort Instructions For Installation, Operation And Maintenance

1.4.1

Display and control panel

Position Designation
18 Display
19 LED Ready for
operation
20 LED Alarm
21 Level LED
22 Backwater flap LED
23
LED Pump
24 Alarm*
25
Backwater flap*
26 Wastewater pump*
65 ESC*
66 Cursor up*
67 Cursor down*
69 OK*
* Push-button
** The automatic mode is automatically re-activated
activated
2019/04
Function, description
Menu structure, see5.66
– Lights up: operation with mains voltage
– Off: operation with battery voltage (if "power outage" appears in the
display)
Flashing: alarm status
Comes on in the event of backwater
– Lights up: backwater flap closed
– Flashing: backwater flap moving
– Flashing: Automatic mode backwater flap deactivated, see display.
– Lights up: Wastewater pump ON
– Flashing: Wastewater pump in manual mode, no pumping off takes place
– Acknowledge the signal generator in an alarm status
– With a power outage: disconnect system control from the battery supply
(complete shut-down, press for >5 sec).
Open (not with backwater) / close the backwater phase
– Switch wastewater pump to manual mode **
– In manual mode: Wastewater pump ON (keep pressed)
– Wastewater pump in automatic mode
– Deleting an entry
– Move cursor one position to the left
– Scrolling in the menu
– Changing a set value
– One level higher in a menu
– Confirm/select an input/menu item
– Move cursor one position to the right
35 / 168
123-45
Pumfpix/Ecolift
Pumpifx/Ecolift Comfort
18
Systeminfos: OK Taste
66
ESC
67
19
FLAP
20
24 13 21 25
Fig. [4]
67
69
OK
23
PUMP
22 26