Install The Pressure Hose - Raven RS1 Guidance And Steering Installation Manual

C 4
HAPTER
FIGURE 4. Raven Steering Valve Installed on Mounting Plate
2. Mount the Raven steering valve (P/N 334-0003-088) to the hydraulic valve mounting bracket (P/N 107-0172-
534) using four 5/16" hex bolts (P/N 311-0052-104) and four 5/16" lock washers (P/N 313-1000-019).
3. Mount the flow switch (P/N 334-0003-085) to the valve mounting bracket using two 1/4"-20 x 2" screws (P/N
311-0050-109), two 1/4" flat washers (P/N 313-2300-009), two 1/4" split lock washers (P/N 313-1000-016), and
two 1/4"-20 hex nuts (P/N 312-1001-074).
FIGURE 5. Raven Steering Valve Mounted on the Machine
4. Mount the hydraulic valve mounting bracket to the machine's radar bracket using the bolts removed in step 1.
NOTE: If needed, the bolts attaching the radar to the bracket may be removed and flipped to make room for
the valve bracket.

INSTALL THE PRESSURE HOSE

1. Locate the machine's steel pressure line.
NOTE: The pressure line runs on the inside of the frame from the rear of the machine. The line bends 45° just
before the hydraulic hose connection. Trace it to the P port on the steering orbital if necessary.
2. Disconnect the machine's pressure hose from the steel pressure line.
16 Case IH Trident 5550 - Non-Steer Ready, Raven RS1™ HDU Guidance and Steering Installation Manual