Install The Pressure Hose - Raven SmarTrax Installation Manual

Install the straight end of the supplied hydraulic hose (P/N 214-1000-796) to the fitting installed in Port B1 of
13.
the POC valve.
Connect the 90° end of the hose to the fitting installed in Port B of the SmarTrax valve.
14.

Install the Pressure Hose

Note:
It may be necessary to install a -6 ORFS M/F 45° elbow fitting (P/N 333-0012-090) or -6 ORFS M/
F 90° elbow fitting (P/N 333-0012-065) on the fitting installed in Port P to achieve the connection.
Pressure Connections
FIGURE 9.
Locate the pressure port at the back side of the SCV at the rear of the tractor.
1.
If the pressure port is plugged, remove the plug from the machine's SCV. If there already is a hose
2.
connected to the pressure port, disconnect the hose.
Install the 22 mm O-ring (M) to -8 ORFS (M) straight adapter fitting (P/N 333-0012-344) in the machine's
3.
open pressure port. If there already is a fitting, install a -10 ORFS tee fitting (P/N 333-0012-031), then install
a -10 ORFS (F) to -8 ORFS (M) reducer fitting (P/N 333-0012-032) onto the 90° end of the tee.
Install the 90° end of the supplied hydraulic hose (P/N 214-1000-890) on the installed straight adapter fitting
4.
or on the reducer fitting. Reconnect the original hose to the open end of the installed tee fitting.
Pressure Hose Connected at SmarTrax Valve
FIGURE 10.
Manual No. 016-5032-008 Rev. B
Hydraulic System Installation
Installed Pressure
Hose
Installed Pressure Hose
19