Raven RS1 Guidance And Steering Installation Manual page 17

FIGURE 5. Installed U-Bolt
Installed U-Bolt
6. Install the 3/8" - 16 x 3/5" (P/N 311-0054-065) bolt in the WAS rod end mounting bracket (P/N 107-0172-030).
7. Mount the WAS rod end to the bolt, using two of the provided steel spacers (P/N 107-0172-037), and the 3/8"
lock nut (P/N 312-4000-061).
8. Secure the bracket using the provided 5/16" lock nuts (P/N 312-4000-059).
9. With the wheels pointed straight ahead, ensure that half of the WAS stroke is extended.
10. Secure all mounting hardware.
11. Slowly turn the machine's wheels to the left and right locks to ensure the sensor does not bind, is not over
extended, or over compressed.
P/N 016-5032-121 Rev. A
WHEEL ANGLE SENSOR INSTALLATION
WAS Rod End
Mounting Bolt
WAS Base End
11